While the transmission is known for its strength and durability, virtually all transmissions have issues, and the C6 is no different.
How do I identify a C6 transmission?
Look for a seam between the bell housing and the body of the transmission. If no seam exists, the transmission is a C6. If a seam does exist, it will be necessary to inspect the oil pan to determine whether the transmission is a C3 or a C4.
Will a C6 transmission fit a 302 Ford?
The C6 is tuff and will fit. The bellhousing isn’t removable as has been said so you would need a SBF pattern.
What vehicles have a C6 transmission?
This gave it the capability to handle 475 ft-lb of torque. The C6 was used in trucks and cars with larger engines.
- 1978–1991 Ford Bronco.
- 1967–1996 Ford F-Series.
- 1964–1970 Ford Fairlane.
- 1966-1974 Ford Galaxie.
- 1966–1980 Ford LTD.
- 1977–1979 Ford LTD II.
- 1966–1979 Ford Ranchero.
- 1966–1979 Ford Thunderbird.
Is the Ford C6 transmission a 4 speed?
The C6 is a non-electronic, three-speed transmission. The AOD features a four-speed, non-electronic transmission. It was not until 1992 that Ford introduced the electronic version of the AOD, the AODE.
How much HP can a C6 transmission handle?
Yes a c6 will hold 500 hp but not a stock one with 3 high gear clutches or a stock valvebody…. A good upgrade is to remove the wave washer from the forward clutch and fit 5 plates,upgrade the high gear clutch to at least 4 but 5 is better and go with a transgo valvebody kit…
How much is a C6 transmission worth?
$1.00 per cube is normal on a decent motor around here – if it is real good expect a bit more. $100 – $150 for a C6 sounds about right.
Will a C6 fit in a Foxbody?
Active Member. the bellhousing is an integral part of the c6 tranny, meaning it does not come off. so if you are getting a c6 from a big block, it won’t fit a 302.
What engines bolt to a C6 transmission?
The 351m, 400, 429, 460 all bolt up to the C6 transmission without any adapters.
Will a C6 transmission fit in a 66 Mustang?
And it WILL fit into a 65 and 66 just fine. As long as you have the small block trans body with the small block bell housing. They can handle more hp and torque than a C4 and you can also install a trans brake and all of the other aftermarket goodies on it.
Which transmission is better C4 or C6?
The C4 transmission was primarily used in cars. The C6 transmission could handle more power. Due to the ability to handle more power, the C6 transmission was used in many Ford trucks with bigger engines, and in larger cars that were manufactured with bigger engines.
Is a C6 transmission good?
Registered. The C6 is the strongest, most durable light duty automatic Ford has made. It was designed in the 60’s during the horsepower wars. The E4OD / 4R100 is not necessarily a “crap” transmission, it is based on the C6.
Can you add overdrive to a C6 transmission?
Adding overdrive to a C6 is physically impossible, but the 4R100 can donate its forward planetary gear set for shorter first and second gear ratios. This creates a “wide-ratio” C6.
How strong is a C6 transmission?
As mentioned, the C6 transmission is quite strong and was paired with many of the larger V8 engines from Ford. This 3 speed automatic transmission was designed to handle up to 475 lb-ft of torque, although the C6 with the aftermarket upgrades used for drag racing can handle significantly more torque.
How does a C6 transmission shift?
The transmission will shift through the gears, but will not downshift back to low gear when coming to a stop. … There is a delayed transmission engagement or it will not engage forward or in reverse. • The transmission slips in forward and reverse and a whining noise comes from the front pump or torque converter area.
Will a C6 transmission fit a 351W?
Registered. — No, that 351W will not bolt onto your 351M C6. — No, all 351W engines used the 351W bellhousing pattern, shared by the 302, 289, 351C, and 300-I6. — Your C6 uses a pattern shared by the 351M/400M (same engine block), and 429/460.